download

Observe safety instruction on raising the vehicle. If necessary, when replacing linings, reset CBS display in accordance with factory specification. Note: After completing work: Fully depress brake pedal several times so that brake linings contact brake disks. When installing new brake linings at front and rear axles, brake fluid level must be brought up to “MAX” marking. Hold ignition key for at least 30 seconds in position “1″ without starting engine. This clears a fault entry in the RAM This prevents the brake wear indicator lamp from lighting up again. Remove plastic plugs (1). Right side: Disconnect plug connection for brake lining wear sensor. If necessary, replace brake lining wear sensor. Release guide screws (2) with special tool 34 1 080. Installation: Only clean guide screws, do not grease. Check threads. Replace all guide screws which are not in perfect condition. Tightening torque