download
INSTALLATION INSTRUCTIONS NOTE: For easier assembly and installation, vehicle and all snowplow components should be on a smooth, level, hard surface, such as concrete. 1. On the driver side of the truck, remove the outermost fastener securing the plastic bumper cover to the splash pan. Retain the fastener for reinstallation if the plow is removed. Then, fold the outermost tab on the plastic bumper cover up to allow for easier pushplate installation. 2. Trim the splash pan as shown to allow for easier pushplate installation. 3. Repeat Steps 1 and 2 on the passenger side. 4. On the driver side of the truck, remove the tow hook fasteners and tow hook. Retain the tow hook for reinstallation if the plow is removed. Retain the fasteners for reinstallation in the following step. 5. Attach the driver-side pushplate to the truck frame using the original tow hook fasteners. Tighten the fasteners so that the pushplate is firmly against the bottom of the frame, but do not fully tighten at this time. 8. Repeat Steps 4–7 on the passenger side of the truck. 9. Install the cross bar using four 1/2″ x 1-1/2″ cap screws and 1/2″ locknuts. Hand tighten fasteners. 10. Check for a connecting arm distance of 29-1/8″ ± 1/8″. If the connecting arm distance is not within 29-1/8″ ± 1/8″, then loosen the tow hook fasteners on one or both pushplates and shift the pushplate(s) in the appropriate direction to obtain