download
Introduction Some 2009 model year Venza vehicles may experience a condition where the front or rear door panel trim delaminates. Improved door panels have been developed to correct this condition. Figure 1. Repair Procedure Front Door 1. Disconnect the cable from the negative (-) battery terminal. 2. Using a molding remover, disengage the 3 claws and remove the front door inside handle bezel plug. 3. Remove the power window regulator master switch assembly with front door armrest base panel (for Driver Side). A. Using a molding remover, disengage the 2 clips and 4 claws. B. Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel. 4. Remove the power window regulator switch assembly with front door armrest base panel (for passenger side). A. Using a molding remover, disengage the 2 clips and 4 claws. B. Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel. 5. Remove the courtesy light assembly. A. Using a plastic pry tool, disengage the claw. B. Disconnect the connector and remove the courtesy light assembly. 6. Remove the front door trim board sub-assembly. A. Remove the 2 screws. B. Using a clip remover, disengage the 10 clips. C. Pull out the front door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration. D. Raise the front door trim board sub-assembly and remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.