Mazda 3 Smoked Rear Reflector with LEDs Installation Instructions
download
1) Remove covers on both sides of hatch. (below) 2) Use a 10mm socket (with extension) to remove the nuts that secure the rear tail lamps. (right) 3) Remove both of the rear tail lamps. This may require a small amount of force as there are plastic ball/socket joints that hold the lamps in place. Once the lamps are free, disconnect the wiring harnesses from the bulb sockets. (right) 4) Use a flat-head screwdriver to remove the large fasteners that secure the rear bumper underneath the car. They are somewhat difficult to remove. (left) 5) Use a Phillips-head screwdriver to remove the screws that secure the rear bumper to the fenders. The screws are just above the wheel where the rear bumper meets the fender. (right) 6) Use a Phillips-head screwdriver to remove the screws that secure the rear bumper to the wheel well liner. The screws are underneath the car at the very rear of the wheel wells. (left)
1) Remove covers on both sides of hatch. (below) 2) Use a 10mm socket (with extension) to remove the nuts that secure the rear tail lamps. (right) 3) Remove both of the rear tail lamps. This may require a small amount of force as there are plastic ball/socket joints that hold the lamps in place. Once the lamps are free, disconnect the wiring harnesses from the bulb sockets. (right) 4) Use a flat-head screwdriver to remove the large fasteners that secure the rear bumper underneath the car. They are somewhat difficult to remove. (left) 5) Use a Phillips-head screwdriver to remove the screws that secure the rear bumper to the fenders. The screws are just above the wheel where the rear bumper meets the fender. (right) 6) Use a Phillips-head screwdriver to remove the screws that secure the rear bumper to the wheel well liner. The screws are underneath the car at the very rear of the wheel wells. (left)
Tags: mazda
