download
This installation manual shows an example of an installation on a Toyota Tacoma; however, the installation may vary for your vehicle, so it may be necessary to consult the Toyota service manual for specific instructions for your year model. Tools Needed: 10mm nut driver or socket, #1 Phillips screwdriver, and Trim Removal Tools (Optional) Be advised: These instructions may not include specifics for all vehicle configurations. 1. Set Parking brake and adjust steering wheel to various settings to facilitate removing the Instrument panel. 2. Partially remove the driver’s side kick panel. a. Using your hands, gently pull straight back on the kick panel. There are 2 release clips; one is shown below. The other clip is directly below the one shown. 3. Remove the coin tray. a. There are 4 clips that hold the tray in place. Gently pull straight out from the dash to remove the tray 4. Remove the driver’s side, lower instrument panel. a. Using a 10mm socket, remove the two bolts shown in the following photos. b. It’s not necessary, but it makes room to pull the door seal out and away from the instrument panel. This allows room to get your fingers or trim removal tool behind the panels. c. Starting on the lower left-hand side, gently separate the lower instrument panel by pulling straight out from the dash. i. When it’s completely separated, lower it to the floorboard. d. Remove the Instrument Panel bezel. i. Using a #1 Phillips screwdriver, remove the screws shown in the photo below. Note: make sure that good contact between the screwdriver and screw is made to ensure that the head is not stripped.