note: when prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. take care not to scratch the dashboard and related parts. 1. detach the clips, and release the retaining tabs (a), then pull the clock out. disconnect the clock connector (b) and hazard warning switch connector (c). dashboard removal/installation srs components are located in this area. review the srs component locations, and precautions and procedures in the srs section before performing repairs or service. note: when prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts to prevent damage. an assistant is helpful when removing and installing the dashboard. take care not to scratch the dashboard, body and other related parts. put on gloves to protect your hands. 1. make sure you have the anti-theft code for the radio, then write down the frequencies for the radio’s preset buttons. 2. disconnect the negative cable from the battery. 3. remove these items: center console glove box door opening trim, both sides as necessary, coupe front door opening trim, both sides as necessary, sedan front pillar trim, both sides coupe sedan 4. disconnect the combination switch connectors, ignition switch connectors and driver’s airbag connector, and lower the steering column. to prevent damage to the steering column, wrap it with a shop towel. driver’s side:

Download