download

Top section of reservoir, removing – Remove left engine cover – 1 – . – Where applicable, remove overflow hose – 2 – from reservoir – 3 – . – Remove nut – 1 – and bolt – 4 – . – Pull top section of reservoir upwards out of bottom section. Bottom section of reservoir, removing – Remove left front wheel. – Remove left front wheel housing liner:::::> Body Exterior – Repair Group 66 . – Remove bottom section of reservoir – 2 – - arrows – . – Swivel bottom section of reservoir slightly to rear. Note: • If it is not possible to swivel bottom section of reservoir, remove bolt – 4 – and detach cross member – 1 – . - Where applicable, detach overflow hose – 3 – from reservoir section. – Disconnect electrical connections – 2 … 4 – . – Press release tab and pull off hose connector – 1 – . – Pull off washer fluid pipe – 5 – . – Remove washer fluid reservoir downwards. Installing Washer fluid reservoir – Audi A4 84, removing and installing Install in reverse order of removal, noting the following: Note: • Clean thread of bolts from remnants of locking fluid using wire brush. Then apply locking fluid and fit bolts. Locking fluid Parts Catalog. • Clean tapped holes from remnants of self-locking bolts or locking fluid (e.g. using a thread tap). Otherwise the bolts can shear off if they have to be removed again later. – When installing, ensure that the water hose audibly engages in the connection on the washer fluid pump. – Tighten bolts in sequence – 1 … 3 – . Tightening torques