download
Removal 1. Open engine compartment hood and fit paint protection covers to fenders. Raise and support vehicle. Remove wheels. 2. Release the tension on the parking brake cable by moving the parking brake caliper lever away from the cable end. Remove cable from parking brake cable lever. See Fig. 32 . 3. Remove the parking brake cable from the rear brake caliper. On vehicles with manually adjusted parking brakes, remove the retaining clip. See Fig. 33 . On vehicles with self-adjusting parking brakes, release the tabs on the parking brake cable housing. See Fig. 38 . NOTE: To prevent the loss of brake fluid, apply the brake pedal hold down tool and adjust to hold the brake pedal down 1.6″ (40 mm). Install a bleeder bottle to the bleed nipple and loosen the bleed nipple. 4. Remove union bolt from the rear brake caliper hose and discard sealing washers. See Fig. 61 . Remove brake hose from rear brake caliper. 5. Tighten the bleed nipple and remove the bleeder tube and bottle. Remove and discard the rear brake caliper retaining bolts. See Fig. 62 . Remove the caliper. 6. Clean and inspect all associated parts. Installation CAUTION: Retracting the caliper piston may cause the fluid reservoir to overflow. Remove brake fluid spillage immediately from paint work with clean water. NOTE: The left rear brake caliper piston retracts counterclockwise and the right rear caliper piston retracts clockwise. 1. Using the Brake Caliper Piston Retractor Tool (206-080) and Crankshaft Pulley/Damper Remover (303- 588), fully retract the rear brake caliper piston into the caliper housing. See Fig. 64 . NOTE: Make sure the piston location mark is in the correct position so that the