download
SYMPTOM/CONDITION: DIAGNOSIS: 1. Verify the rear of the sunroof glass to roof flushness concern. 2. UNCALIBRATE THE SUNROOF. a. b. c. d. e. 3. RECALIBRATE THE SUNROOF a. b. c. 4. If the uncalibrate/recalibrate procedure did not eliminate the sunroof glass to roof fit, use the procedures outlined in TechCONNECT(R) BODY/SUNROOF/GLASS PANEL/ADJUSTMENTS to adjust the glass panel. If the sunroof glass is now flush, perform the Repair Procedure. If the vehicle operator describes or experiences the Symptom/Condition, perform the Repair Procedure. Insure the battery is at least 12 Volts. Place the ignition switch in RUN position. Locate the sunroof fuse (Fuse 44 in the Power Distribution Center located in the trunk). While the sunroof is still in motion, have an assistant remove the sunroof fuse. Reinstall the sunroof fuse. Press and hold the sunroof vent switch until it stops at the full vent position. Verify sunroof operation by opening, closing, and venting the sunroof. If the uncalibrate/recalibrate procedure corrected the sunroof glass to roof fit, perform the Repair Procedure.