download
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) and fix the wiring harness to an appropriate place where it will not be pulled by mistake while servicing the vehicle. 1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, inspect the front wheel alignment and adjust it if necessary. (See FRONT WHEEL ALIGNMENT ). LOCKNUT REMOVAL NOTE 1. Knock the crimped portion of the locknut outward using a small chisel and a hummer. 2. Lock the hub by applying the brakes. 3. Remove the locknut. BRAKE CALIPER REMOVAL NOTE 1. Remove the brake caliper component from the steering knuckle and suspend it out of the way using a cable. WHEEL HUB, STEERING KNUCKLE COMPONENT REMOVAL NOTE 1. Separate the shock absorber from the wheel hub, steering knuckle component by tapping the upper part of the steering knuckle with a hammer.