download
Some affected vehicles may experience any or all of the following DTCs and/or symptoms after the vehicle is operated in very cold weather (approximately ?22o F (?30oC) or colder) after a short drive (5 ? 10 minutes) followed by a 15 ? 20 minute cold soak.DTC P0657 P1590 U0101 None U0100 P0201 ? P0206 This condition is caused by condensation freezing inside the relay, rendering it inoperative. Should you suspect very cold weather has caused this condition in an affected vehicle, follow the procedure below to identify and replace described relays with modified parts. AFFECTED VEHICLES 2007?10 Outlander (2.4L 4 cyl & 3.0L V6) built prior to November 16, 2009. 2008?10 Lancer, built prior to November 16, 2009. 2008?10 Lancer Evolution built prior to November 16, 2009. 2009?10 Lancer Sportback built prior to November 16, 2009. PROCEDURE 1. Turn the ignition switch to the LOCK (off) position. 2. Locate the relay box inside the engine compartment and open the cover. 3. Refer to the illustrations on pages 2 through 4 of this TSB and replace relays as follows: Vehicles equipped with A/T or CVT ? Replace the Injector Relay, Starter Relay, Throttle Actuator Control Motor Relay, AT/CVT Control Relay with p/n 8627A024, and replace the MFI relay with p/n MR400709. Vehicles equipped with M/T or SST ? Replace the Injector Relay, Starter Relay, Throttle Actuator Control Motor Relay with p/n 8627A024, and replace the MFI relay with p/n MR400709. MIL Status ON ON ON OFF OFF OFF Relay ETV A/T (CVT) A/T (CVT) STARTER MFI Injector Symptom Engine torque is limited Limp Home Mode Limp Home Mode Engine will not turn over Engine will not start Engine will not start