Remove all items from the packing tube. You should have the following before beginning: * (2) Gas springs (RT-QL-170-6A – swivel) – Be sure to cycle them a few times before installing. * (4) 3/16″ multi-grip #2 rivets (used on hood brackets) * (2) ball-studs and (2) washers (QTY 2) * (2) ball-stud mounting brackets Step 2 – Gather the required tools. Please gather the following tools before you begin the installation: * Power Drill * 3/16″ or #11 indexed drill bits * 10mm socket and 13mm deep-well socket with wrench * Fine permanent marker or felt tip pen * Tape measure or ruler * Masking tape * Hammer & center punch * Rivet gun, capable of 3/16″ rivets Note: Only use the rivets supplied in the QuickLIFT system. Step 3 – Mark at 19-3/4” A. Open hood. B. Place a piece of masking tape on top of hood’s edge as shown. Carefully measure along the hoods edge, starting at the corner nearest windshield. Place a mark at 19-3/4” . This mark will be used to align the centerline of the mounting bracket in the following step.