download
Part 1 – Check Alignment and marking for drilling. Picture 1: Remove the plastic cover below the side chassis. Picture 2: Fit the Square fastener at the side extension. Picture 3: At both end of the side extension add 2 nuts as a spacer at the last fastener. Picture 4: Place the side extension to the chassis to check alignment. Picture 5: Use 3 car jacks to hold the side extension. Center jack should place toward the rear. Picture are align with the chassis Picture 9: Make sure no gap is in between the side extension and chassis. Picture 10: You need a crayon. Picture 11: Using the crayon to draw a line at the chassis. Picture 12: Make sure there are no gaps in between, than remove the side extension Picture 13: Prepare the side extension ready with all marker maker on the fastener holder using of double marker maker are advised. Picture 14: Use masking tape to stick over the marker maker Picture 15: Make sure all the masking tape can stick to release the tape from the marker maker. Picture 16: Place the side extension to the chassis with the car jack Picture 17: Between the side extension and chassis please place cardboard. Picture 18: Slowly adjust the car jack and shift the side extension to the line marking. Picture 19: The purpose of placing the cardboard in between the side extension are to form a gap after the side extension has adjust in place.