download

Accelerator pedal cable -1- connected to accelerator pedal and routed over the Throttle actuator control module cable quadrant. Remove clip -3- from notched section of cable sleeve -4-. Fully depress accelerator pedal to Wide Open Throttle position. Note: Either use a second technician or a mechanical device to depress the accelerator pedal. Vehicles with manual transmission Move notched outer sleeve in or out of grommet -4- (as necessary) until Wide Open Throttle position is just reached. Re-install clip -3- into the first completely exposed notch closest to the top of the grommet. Vehicles with automatic transmission Move outer sleeve in or out of grommet -4- (as necessary) until Wide Open Throttle position is just reached and the kick-down switch clicks audibly. Re-install clip -3- into the first completely exposed notch closest to the top of the grommet. All vehicles Release accelerator pedal (remove mechanical device, if used). After adjusting, check the Closed and Wide open Throttle stops. Vehicles with automatic transmission, adjustment checking Test and auxiliary equipment required Fluke 83 Multimeter VW 1594 Adaptor kit Disconnect 2-pin harness connector from kick-down switch In engine compartment on firewall Connect multimeter between kick-down switch terminals using jumper wires from VW 1594 adaptor kit. Measure resistance across switch. Specified Value: ? Slowly depress accelerator pedal until Wide Open Throttle is reached. If properly adjusted, following conditions will be met: Shortly after kick-down point, resistance must drop to 0 Accelerator pedal must almost be up to the full travel stop